Squid 3.1 必須開 ipv4,ipv6
今天在更新主機到 fedora12 時,squid 一直不能用,顯示 comm_open: socket failure: (97) Address family not supported by protocol,後來上網查找,才知 fedora12 的 squid rpm 檔,內定開啟 ipv4 與 ipv6 ,因為我將 ipv6 disable ,所以不能用,解決方法是將 ipv6 打開,或是重新編譯 squid 將 ipv6 disable,就可以了
迴響
我只是愛你的有趣博客
我想說,你真的幫助我理解的主題 Squid 3.1 ??? ipv4,ipv6 | ??
Squid 3.1 必須開 ipv4,ipv6 | 豬窩
Hey there! Do you know if they make any plugins to
protect against hackers? I'm kinda paranoid about losing everything I've worked hard on. Any recommendations?
Squid 3.1 必須開 ipv4,ipv6 | 豬窩
I like the helpful information you supply to your articles.
I'll bookmark your weblog and check again right here regularly.
I am somewhat certain I will learn a lot of new stuff proper here!
Best of luck for the next!
Squid 3.1 必須開 ipv4,ipv6 | 豬窩
This is a topic which is close to my heart... Cheers!
Exactly where are your contact details though?
Squid 3.1 必須開 ipv4,ipv6 | 豬窩
Hello, just wanted to tell you, I enjoyed this blog post.
It was inspiring. Keep on posting!